Anyone able to get 3.0.4 fpc to compile lazarus 2.0.2 on rasberry PI?-This is written from a Raspberry pi 3 - did you solve it? because I am on Laz trunk and FPC trunk and there are no problems at all...
latest on back ports is 1.8.4
I had also problems and could only compile an older nightly edition Lazarus 1.9 (not the latest). Other versions where also problematic. However after installing the latest Raspbian operating system Buster, you get Lazarus 2.0.0 and FPC 3.0.4 by simply:No. Use - one time - fpcdeluxe. There are no problems. Again written from a Raspberri Pi 3 b. This weekend from a RPi 4 I hope... 8-)
sudo apt-get install lazarus
No. Use - one time - fpcdeluxe. There are no problems. Again written from a Raspberri Pi 3 b. This weekend from a RPi 4 I hope... 8-)
If there are any problems, report back. I can compile ANY (stable) version that supports armhf on a Raspberry Pi without problems. Lazarus too...It's not
Will have a look to fpcupdeluxe and memory swap size. :(
Frustrating. It would be nice if a simple .deb installer was available on Sourceforge. I'm thinking going back to a older trunk 1.90 dailly build which worked fine for me and just type "make clean bigide". Strange enough "make clean bigide" doesn't work for the latest dailly build. Never had these problems in amd64.If you try it with the simply fpcupdeluxe installer, you need not to deal with packages. To have some 'nice' deb packages you need more peoplepower for building .deb packages for all flowers of linux with different 'spezialities'. This is on of the reasons for fpcupdeluxe - you can build direct from the sources with a well mainted tool (THX to Alfred !!!) on a lot of platforms.
Be careful with Buster: even I went through hoops after installing it on a RPi 3.... and I am very experienced.Stretch is no longer available. You get default Buster. I'm glad with it since it has Lazarus 2.0.0 (better then 1.6.2), so that's fine for me