Forum > General

Not able to add any component after an application has run

<< < (5/5)

andrew Bubble:
Hi Paweld

Just to confirm I have just put a legacy PI Os 64 bit (bullseye) on an SD card and after reboot

Repeated my other steps, I have installed the stable version of Lazarus and the install completed with no errors.

I have also had no issues as previously stated with adding buttons, stopping the application etc.

However I will do as you suggested and use the trunk version of Lazarus on a PI running 64 bit (bookworm).

Regards Andrew

Navigation

[0] Message Index

[*] Previous page

Go to full version