Forum > General

How to dock project explorer to the right pagecontrol

(1/1)

LeoBruno:
Hi:

Is it possible to dock the project explorer to the area where the component's tabSheet is docked?

I'm using AnchorDocking, AnchorDockingDsn, DockedFormEditor and Lazarus 2.2.2 fpc 3.2.2

Also:

After undocking one of the originally docked forms, how to dock it back to it's original docking position?

Thank's

PascalDragon:

--- Quote from: LeoBruno on August 10, 2022, 03:28:58 pm ---Is it possible to dock the project explorer to the area where the component's tabSheet is docked?
--- End quote ---

Pick the Project Inspector at its header (the gray bar with the red x below the title bar) and drag it onto the tab bar where the Component list is docked. You should see a blue highlight at the tab bar. Release the header and the Project Inspector should appear there.


--- Quote from: LeoBruno on August 10, 2022, 03:28:58 pm ---After undocking one of the originally docked forms, how to dock it back to it's original docking position?
--- End quote ---

Same as above: pick the offending window at its header and move it to where you want it. A blue highlight will show you where it will be docked (might take some fiddling to find the right position).

Note: if you don't have the headers, make sure they're enabled in Tools -> Settings -> Environment -> Docking / Anchordocking -> Show headers.

LeoBruno:
Thank's again.

You are always saving me!


--- Quote from: PascalDragon on August 11, 2022, 09:11:32 am ---
--- Quote from: LeoBruno on August 10, 2022, 03:28:58 pm ---Is it possible to dock the project explorer to the area where the component's tabSheet is docked?
--- End quote ---

Pick the Project Inspector at its header (the gray bar with the red x below the title bar) and drag it onto the tab bar where the Component list is docked. You should see a blue highlight at the tab bar. Release the header and the Project Inspector should appear there.


--- Quote from: LeoBruno on August 10, 2022, 03:28:58 pm ---After undocking one of the originally docked forms, how to dock it back to it's original docking position?
--- End quote ---

Same as above: pick the offending window at its header and move it to where you want it. A blue highlight will show you where it will be docked (might take some fiddling to find the right position).

Note: if you don't have the headers, make sure they're enabled in Tools -> Settings -> Environment -> Docking / Anchordocking -> Show headers.

--- End quote ---

Navigation

[0] Message Index

Go to full version