Forum > Designer
qt5 built IDE wrecks form designer
(1/1)
LeoBruno:
HI:
I built lazarus IDE with qt5 in order to get dark ide theme on Windows following the tip found here: https://forum.lazarus.freepascal.org/index.php/topic,55550.msg435622.html#msg435622
After that, the top and bottom of the form designer became wrecked:
The top area is cut and there is a section bellow the bottom area.
What I mean is:
If I align a control to the top, only part of the control shows up.
If I align a control to the bottom, it does not touch the bottom limit of the form.
This only happens at design time
I have attached 2 images to depict this issue
Any tips on how to solve this?
Thanks in advance!
zeljko:
Does it work ok without dark theme ? Seem that designer form clientrect is offsetted by tabbar.
LeoBruno:
Hi:
I tested without the dark theme and the issue seems to have something to do with docked forms packages.
I used the qt5dll contained on this link https://disk.yandex.ru/d/_LWZvwTJG0x7vw
Before the installation of docked forms (AnchorDocking 1.0, AnchorDockingDsgn 1.0 and sparta_DockedFormEditor 0.0) the form editor was fine.
I attached a print
LeoBruno:
The issue is for sure, related with sparta_docked forms:
After uninstalling it and installed the "DockedFormEditor 0.0", it´s working fine.
PascalDragon:
--- Quote from: LeoBruno on July 18, 2022, 10:55:57 pm ---The issue is for sure, related with sparta_docked forms:
--- End quote ---
The Sparta one isn't recommended anymore anyway and has even been removed in Trunk.
Navigation
[0] Message Index