New "FpDebug: Only Dwarf supported" dialog in Lazarus 2.2.0

Forum > Debugger

(1/1)

rcmz:
hi to all,

using lazarus 2.2.0

when i open a project build with 2.0.10 and open in 2.2.0 this is ok when I try to run it in 2.2.0 i get
"The project does not write in Dwarf format. The fpdebug internal Dwarf-debugger supports only Dwarf"

then i have 4 buttons:
enable Dwarf 2 with sets Dwarf 2 (-gw) Dwarf 3 (-gw3) Cancel

Which button is the correct one ?

TIA
Ramiro

Martin_fr:
All three will work.

"Dwarf 2": this is the minimum. It has no advantages. E.g., it can not display watches for "set of". IMHO, no reason to use at all.

"Dwarf 2 with sets": Use this if:
- you work with variants (not yet avail in dwarf 3, will be fixed at some point)
- you need to often switch between the new FpDebug and the old GDB
-> pro: GDB currently has the better disassembler, and gdb currently often has better stack WHILE your app is in the Win-Kernel
-> contra: GDB occasionally crashes.

"Dwarf 3": Best setting, unless one of the above condition applies to you.

The main diffs between the 3 settings are the display of some types. E.g. AnsiString may be displayed as PChar when using "dwarf 2 with/without". (though this may be OS dependent)
As for the big issues, like "property" inspection => all 3 are equal.

rcmz:
thx

for the info.

Thx.
Ramiro

Martin_fr:
Changed thread title (message subject).

Martin_fr:
About the new dialog: https://wiki.lazarus.freepascal.org/DWARF

More info on debuggers
https://wiki.lazarus.freepascal.org/Debugger_Status
https://wiki.lazarus.freepascal.org/LazDebuggerFp
https://wiki.lazarus.freepascal.org/Category:Debugging

Navigation

[0] Message Index