Hello,
When debugging at the assembly level, the top part of the assembly window seems to always be "empty" (no code shown in it) and when stepping the scrolling seems to occur just one line above the current instruction causing it to disappear once it's been stepped.
What follows is a piece of what the assembly window is showing, the top part of the window having no code:
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
0000000000000000 ......
000000010000BB29 EB07 jmp +$07
000000010000BB2B 488D05D6680100 lea rax,[rip+$000168D6]
000000010000BB32 90 nop
000000010000BB33 488D642428 lea rsp,[rsp+$28]
000000010000BB38 C3 ret
000000010000BB39 0000 add [rax],al
000000010000BB3B 0000 add [rax],al
000000010000BB3D 0000 add [rax],al
000000010000BB3F 005357 add [rbx+$57],dl
000000010000BB42 56 push rsi
000000010000BB43 4154 push r12
000000010000BB45 4155 push r13
000000010000BB47 488D6424E0 lea rsp,[rsp-$20]
000000010000BB4C 4889CB mov rbx,rcx
000000010000BB4F 4889D6 mov rsi,rdx
000000010000BB52 4C89C7 mov rdi,r8
Is this behavior due to some configuration setting not being set properly or is this a bug ?
Thank you for your help.