Ending my integration of attabs, i've a small howto question:
is it suppurted by the control, or has it to be done by the programmer, to achieve:
show the scrollbutton only if needed (if there is something to scrol) ?
By that i found a small glitch where i'm not sure whether it's due to my own missettiings or due to a glitch: artifacts may occur. See attached testcase and images. For to reproduce:
- start testcase, you will see three tabs
- press the plus button, a tab4 will appear
- press the plus button again, a tab5 will appear which is only partially shown (truncated, that's ok). Look at the left side. you wil see an artifact (just as if a truncated tab's painting tries to finish at the start pos of the control.
- click onto tab5 so that it becones active. You'll see an artifact above the plus sign.
- click the plus button again and see what happens.