i suggested use "LAMW"
http://wiki.lazarus.freepascal.org/LAMW
FAQ: [Thanks to @developing!]
#Question: How do we can design a layout that shown same in real device?
[Answer]: You should use the component properties:
"Anchor",
"PosRelativeToParent",
"PosRelativeToAnchor",
"LayoutParamHeight",
"LayoutParamWhidth"
Example:
1-Put a "jTextView" component on your AndroidModule form:
Set "PosRelativeToParent"
"rpCenterHorizontal" [True]
"rpTop" [True]
2-Put a "jButton" component on AndroidModule form:
Set "Anchor" to "jTextView" (Because you should set position relative with "jTextView")
set "PosRelativeToAnchor"
"raBelow" [True]
3-Put a "jEditText" component on form:
Set "Anchor" to "jButton".
Set "PosRelativeToAnchor"
"raBelow" [True]
NOTE: Anchor setting is most important section of this design,
because your component position depends on this property.
And for change width and/or height of each components you should
change/configure "LayoutParamWhidth" and/or "LayoutParamHeight".
I just installed and configured LazToApk v0.9.0.37 and after a while and following all the steps described in the PDF guide I could create my first apk.
What could be wrong? My app is only one button and one label.
Do You have any clue if the bug will be fixed?