Recent

Author Topic: Reneme all RxFPC modules - add RX prefix to all files  (Read 4486 times)

alexs75

  • Full Member
  • ***
  • Posts: 112
Reneme all RxFPC modules - add RX prefix to all files
« on: September 15, 2016, 07:22:48 am »
Start of discussion - http://forum.lazarus.freepascal.org/index.php/topic,34014.msg222109.html#msg222109

This is a very serious question, because it will apply to all users. And if it will cause a big problem?

kit

  • New Member
  • *
  • Posts: 39
Re: Reneme all RxFPC modules - add RX prefix to all files
« Reply #1 on: September 17, 2016, 06:58:18 am »
It's not big problem.

alexs75

  • Full Member
  • ***
  • Posts: 112
Re: Reneme all RxFPC modules - add RX prefix to all files
« Reply #2 on: September 21, 2016, 11:45:12 am »
please - test

kit

  • New Member
  • *
  • Posts: 39
Re: Reneme all RxFPC modules - add RX prefix to all files
« Reply #3 on: September 22, 2016, 07:03:13 am »
procedure TRxDBGridExportSpreadSheet.DoExportColWidth;
var
  FW:integer;
  C:TRxColumn;
  i: Integer;
begin
  FW:=FRxDBGrid.Canvas.TextWidth('W');
  FCurCol:=0;
  for i:=0 to FRxDBGrid.Columns.Count - 1 do
  begin
    C:=FRxDBGrid.Columns as TRxColumn;
    if C.Visible then
    begin
      FWorksheet.WriteColWidth(FCurCol, Max(C.Width div FW, 20));
//      FWorksheet.WriteColWidth(FCurCol, C.Width, suPoints);
      inc(FCurCol);
    end;
  end;
end;

rxdbgridexportspreadsheet.pas(425,50) Error: Identifier not found "suPoints"
« Last Edit: September 25, 2016, 06:58:04 am by kit »

Thaddy

  • Hero Member
  • *****
  • Posts: 14160
  • Probably until I exterminate Putin.
Re: Reneme all RxFPC modules - add RX prefix to all files
« Reply #4 on: September 22, 2016, 10:32:50 am »
Oh, well,
Same story again.
Plz add a simple example in source code that shows the issue.
This is not reproducible.

Please show us some real world code!
Specialize a type, not a var.

 

TinyPortal © 2005-2018